OME front spring install on Bilstein 5100 & SPC UCA's

[ClamChowder]

Hey All,

I'm looking for some help installing my OME 886 springs up front on my '07 Sport 4WD V6.

I already have installed SPC UCA's, Bilstein 5100's, ARB Deluxe Bull (moose) Bumper, and my rear is set up with OME/Bilsteins already.

I have these new springs, and have no idea where to go from here.

I've read through some write-ups and watched some videos, but I legitimately only need to put the springs in - and then have an alignment.

Is there anyone who can either point me to a good instructional (if it exists) for this (or a similar) situation?

I'm open to paying a "tutor" to consult if someone wants to walk me through it on video even - because I really just want these on my truck and luckily have tools/garage/parts for a few more weeks here in ya ole "civilization" in WA.

 

[firebirdguy]

im sure others will chime in with step by step instructions or a link to tutorials on here. but basically you just need to undo the big center bolt on the top hat that will release the spring but first use either a spring compressor to hold it you can rent for free from auto parts stores, or do the on the car version where you use the weight of the vehicle to hold pressure on the spring then slowly release the jack to release the pressure, & reverse the steps to install the new spring.

you can check youtube for 4runner or tacoma spring install, there are quite a few videos showing the procedure. or down load the toyota service manual thats in a sticky on here.

 

[Tironeous]

https://www.youtube.com/watch?v=5E6u7dC7EHg&feature=youtu.be

https://www.youtube.com/watch?v=jo0FJSi-KYs&feature=youtu.be


Sent from my iPhone using Tapatalk