Rear sway bar endlinks

[T4R916]

What are you guys using? I have an adjustable heim endlinks but they squeak all the time when its dry. Tired of spraying lithium grease on it every 2 days

 

[TheDailyDownshift]

For heim joints, try using motorcycle chain lubricant spray instead. It leaves a sticky film of lubricant that lasts a lot longer.

 

[phatcheeks]

I use 2nd gen 4runner endlinks.

 

[gimlithepirate]

Newb question, but what to the rear sway bar endlinks do for you? I think I've got my head pretty well wrapped around the front IFS, but this is the firs time I've had something with a 4 link rear as opposed to leaf springs.

 

[ktom3001]

I used Jeep JK end links. You have to cut one end off to desired length and thread. Add bushings, washer, and a nut and you have a sealed end link.

 

[That_Titanium_4RNR]

Newb question, but what to the rear sway bar endlinks do for you? I think I've got my head pretty well wrapped around the front IFS, but this is the firs time I've had something with a 4 link rear as opposed to leaf springs.

YouTube

YouTube

 

[techno]

I use 2nd gen 4runner endlinks.

Same. They are the perfect length for my mild lift. At normal ride height they are under no load.

 

[jacob7071]

I made some of these. Covered the bushings with some poly grease and haven't heard a peep in over 2 years. I don't offroad though, so can't attest to the durability on the trails.

Built New Swaybar Endlinks for my Runner

 

[Caldizzle]

I use 2nd gen 4runner endlinks.

3rd on this. I got some Moog ones off Amazon. Been fine as far as I can tell, but i should've spray painted them before I put them on. The coating Moog puts on it crusts pretty quick.

 

[smokey73]

I made some of these. Covered the bushings with some poly grease and haven't heard a peep in over 2 years. I don't offroad though, so can't attest to the durability on the trails.

Built New Swaybar Endlinks for my Runner

I did pretty much the same thing. I do off road, and they hold up pretty well. however, if Im doing more than just dirt road driving and plan on getting flexy, I disconnect both sway bars.

 

[L8Shift]

I went with Pro-Forged 2nd gen end links. Fine for over a couple years now..

Proforged - Severe Duty Chassis Parts :hat:

Proforged 113-10144 End Link

 

[WarChild]

Are you lifted? I have a 3in lift and I use the JKS 2000 quick disconnect adjustable links. Perfect size. No cutting.