removing oil cooler from engine block during power steering rack replacement

paraordnance

New member
I'm replacing a lot of parts: TB, water pump, bearings tensioner, seals, power steering rack, hoses from PS pump (high-pressure side) and the low-pressure side. I almost got everything removed but to slide the power steering rack out I need to loosen up the oil cooler. Where are the bolts that holding oil cooler?
 

Attachments

  • 20200428_192916.jpg
    20200428_192916.jpg
    53.5 KB · Views: 512
Register to hide this ad
I'm replacing a lot of parts: TB, water pump, bearings tensioner, seals, power steering rack, hoses from PS pump (high-pressure side) and the low-pressure side. I almost got everything removed but to slide the power steering rack out I need to loosen up the oil cooler. Where are the bolts that holding oil cooler?

Remove the oil filter, screw the fitting out.
 

Attachments

  • Cars 4Run Blue 8.jpg
    Cars 4Run Blue 8.jpg
    133.1 KB · Views: 499
Remove the oil filter, screw the fitting out.

You saved my day, I gave up trying to figure out how to take oil cooler with the filter in place! I watched the video on youtube by EricTheCarGuy how to remove the rack but it skips through the oil cooler part and his assembly moves away with the filter on. That's what confused me. Thanks, I'm finally removing parts again and will start to put it all back together with new stuff this week.
 

Forum statistics

Threads
278,500
Messages
3,551,672
Members
248,200
Latest member
bobdjr41

Trending content

Back
Top