Show me your compressor mount

[4x4mike]

Not so much. It's a tight fit without moving expensive little Toyota parts around. The ARB wiring harness is also very big and finding hiding places for all that is difficult enough for me to not produce these. Slee makes one.

 

[bjornberg]

Contacted Slee a few months ago, they said they don't do one for the 4th Gens. Insain Fab does one, and it's what I want most, but they won't reply to the messages I've sent. Think I may just go with the Bandi mount. Thanks

 

[drivermod]

2006 V6. Just had to flip the intake tube to the rear of the engine compartment and had just enough room for my Viair setup.

 

[Tkblazer]

Whoa that’s rad

 

[derekdevasia]

Jesus....that's a huge tank under there. Are you worried about it sucking hot air from the engine compartment now instead of the cool air in the fender well?

 

[drivermod]

Jesus....that's a huge tank under there. Are you worried about it sucking hot air from the engine compartment now instead of the cool air in the fender well?

The thought certainly crossed my mind but its not a race car. Not really that concerned. Think about how many people run open air conical filters under hood. No different really. I was actually more concerned with the heat on the compressor. So far not an issue. I usually have the hood up anyway when I use the compressor so that probably helps with heat dissipation.

 

[blackoutt]

Posting a reply in here so I can find it on my phone later. Looking for a mount for 4th gen V8 underhood for ARB twin, I have already used the passenger side rear area for OffGridEngineering dual battery mount.

 

[Jonesy_PNW]

Looks great! Who made the bracket? I would love to order one...

I had a fabricator in my local area make it from scratch! He can make one for you I'm sure!