Utahrunner
New member
I just went through a pretty extensive rebuild after an accident. Replaced the whole Left front corner, battery, radiator, all belts, timing belt, water pump etc. were replaced.
During the rebuild, never had a problem starting right up. Starter was replaced 2-3k miles ago and hasn't been used much.
It will always start first thing in the morning without fail, but later on it takes a few seconds and a few tries sometimes for the engine to grab and start. When we were replacing the timiming belt, we removed the 1st spark plug and replaced it with a new one and applied the gel that I was given. I purchased 6 new ones but we didnt have time to install them all and I was told they were pre gapped for my runner.
After asking around, I have been told that it is most likely a problem with the gap on the spark plugs?
Any ideas?
Thanks for any help
During the rebuild, never had a problem starting right up. Starter was replaced 2-3k miles ago and hasn't been used much.
It will always start first thing in the morning without fail, but later on it takes a few seconds and a few tries sometimes for the engine to grab and start. When we were replacing the timiming belt, we removed the 1st spark plug and replaced it with a new one and applied the gel that I was given. I purchased 6 new ones but we didnt have time to install them all and I was told they were pre gapped for my runner.
After asking around, I have been told that it is most likely a problem with the gap on the spark plugs?
Any ideas?
Thanks for any help