UTEP
New member
Hi,
My Haynes does not have this where I can find it, anyone have this close at hand?
While I got ya…I replaced wheel cylinders and had to tighten just about to what I consider too much to get a small leak to stop. It's been a while since I've done WC's but don't recall having to put that much pressure on the inlet.
Not cross threaded! I hand tightened smoothly till seated and snugged it up to what I thought was reasonable sans torque settings/wrench at hand.
OEM fitting, NAPA WC's.
NAPA suggested some green loctite… I'm not convinced. Opinions?
Thanks,
UTEP
My Haynes does not have this where I can find it, anyone have this close at hand?
While I got ya…I replaced wheel cylinders and had to tighten just about to what I consider too much to get a small leak to stop. It's been a while since I've done WC's but don't recall having to put that much pressure on the inlet.
Not cross threaded! I hand tightened smoothly till seated and snugged it up to what I thought was reasonable sans torque settings/wrench at hand.
OEM fitting, NAPA WC's.
NAPA suggested some green loctite… I'm not convinced. Opinions?
Thanks,
UTEP
