What Did You Do To Your 3rd Gen Today?
- Thread starter pin8246
- Start date
- Status
jasonoflivingston
New member
Filled it full of junk and went for a dump run. Someone tried to buy it off me at the dump. :nod:
quicksilvr
New member
I did my fuel filter today too....on and off with no leaks in about 15 mins. Southern 4runners FTW.
I also changed my Magnafine trans filter. This one had 28k miles on it. Based on this, I will probably run the next one 40k without thinking twice. Fluid was bright red as well.
I also changed my Magnafine trans filter. This one had 28k miles on it. Based on this, I will probably run the next one 40k without thinking twice. Fluid was bright red as well.
TNRunner99
New member
New valve cover gaskets, spark plugs and wires. Did it yesterday but forgot to post. Now I gotta clean the engine compartment, still has mud everywhere from the last trip.
View attachment 118343
View attachment 118343
Last edited:
ti-jean711
New member
Change the exhaust gasket stud and bolt between the first cat on my 2001 4runner 3.4l
what a :crazy: job to do but it's done now Houra houra
what a :crazy: job to do but it's done now Houra houra
Jaketino
New member
I did my fuel filter today too....on and off with no leaks in about 15 mins. Southern 4runners FTW.
I also changed my Magnafine trans filter. This one had 28k miles on it. Based on this, I will probably run the next one 40k without thinking twice. Fluid was bright red as well.
Lucky... I gotta change out my trans filter soon. I didn't do a full flush when I put mine in so I figured it would catch all the extra stuff first then I could put a new one in after.
RonMAIDEN
Super Moderator
I wonder if I should change my plug wires as they are still the originals with 180k on em. Original fuel filter too but I have a new one ready to go in when I get around to it. Even my hatch struts haven't lost their holding power.
Just did the interior spring cleaning getting rid of the winter grime then need to get on to the exterior.
Just did the interior spring cleaning getting rid of the winter grime then need to get on to the exterior.
montana_jeepn
New member
Installed another new rotor today.
Yesterday I did the ISR mod with the Airaid tube and cleaned the throttle body. Think I might need to pull it off again and clean the ICA since I'm getting a high idle at startup.
Yesterday I did the ISR mod with the Airaid tube and cleaned the throttle body. Think I might need to pull it off again and clean the ICA since I'm getting a high idle at startup.
4Running Daily
New member
JayRolla
New member
Drove 5 hours round trip to pick up the Holy Grail from Addictedoffroad. Thanks Scott again for building the best bumper on the market. I know it took some time but was well worth it. Just to let people know if you are worried about AOR's turn time he said he is pretty much caught up on all vehicle plates bumpers by the end of next week. Very nice guy and it was fun talking toyotas!
Attachments
ugamurph
New member
What did you do to your 3rd gen today?
Bump out didn't do it's job.
Here's your Badge of Honor.
Bump out didn't do it's job.
Here's your Badge of Honor.
ugamurph
New member
Skidmarcx
New member
Good eye... I remove the links... IFS sucks I hate these midget arms haha
ugamurph
New member
What do you do to keep the sway bar from moving around? I've used zip ties in the past, but just curious about what other people do to secure it.
- Status
Similar threads
