Where to cleanly place cb radio and PA microphone.

knightsfs4

New member
Have seen some posts, but none with any really clean places to put the CB receiver and the microphone. also where under the truck have you guys been placing your speakers?

Jack
 
Register to hide this ad
i just installed my PA and CB on friday. I'll try to get some pictures on here to show you what i did. The mount for the whip that i used was recommended to me by gaterose and it is great so far. I have a 4 foot whip and a cobra 19 DX IV 40 channel CB radio. I'll try some pictures now. Give me a minute.
 
CB/PA set-up

here they are.
 

Attachments

  • try1.jpg
    try1.jpg
    100.6 KB · Views: 827
  • try2.jpg
    try2.jpg
    66 KB · Views: 855
  • try3.jpg
    try3.jpg
    67.3 KB · Views: 805
  • tryy.jpg
    tryy.jpg
    87.9 KB · Views: 836
  • try4.jpg
    try4.jpg
    69.7 KB · Views: 836
The PA is help in by cable ties, the CB is Velcroed (I'm not sure if that is spelled correctly) to the spot next to my right knee. Hope with helps.
 
I don't even really want the cb, I just want a pa that I can also do what the guy above suggested. I just wanna use one of the blanks and run the wire to the speaker to the front of the car. What do I have to get to do this?
 
Have you tried mounting inside of the glove box? Its clean when not in use and when in use you can either leave the box open so you can change channels or close it and leave the mics out.
 
Sorry for all the questions, but if I get this, what is the thing in the middle of the box? I mean what is supposed to be plugged into that?

Amazon.com: Cobra AC 701 Remote Connector Box for CBR75WXST: Car Electronics
Amazon.com: Cobra 75WXST 40-Channel CB Radio: Car Electronics

The handset plugs into it. It's a whole CB unit channels and everything all in one unit that you can just unplug and hide in a console when not in use...which is what I'm thinking of doing to mine...
 
Radio Shack has decent loudspeakers, I got one there a few years back that was 100W and I didn't need to get an amp to run it. Also, there's a small "male" connector I got from there (had to drive all over town to get it) and I soldered the speaker wire from the PA to the CB.

I don't remember the specific connector I bought, but it was gold colored and had 3 prongs inside it, you only use two of them...hope that isn't too confusing.
 
Well damn. I know you guys know what I'm trying to get at here, but I can't find the products I need to get so that I can do this the way I want to..
 

Members online

No members online now.

Forum statistics

Threads
278,317
Messages
3,554,129
Members
248,016
Latest member
Advally Service

Trending content

Back
Top