Wiring for relay module under the hood

[Tuc4R]

I am getting ready to install a Bussmann relay module, to run my lights and such. I Also have a Noco battery charger and Rago solar panel adapters that I want to install, to make it easier to plug both of those in.
What is the best way to wire all this together, advice please.
I have an 80amp breaker, 4 AWG wire and a ground block. I was wondering if I should get another block for 12V, in case I want to add some other small lights like under the hood. Just trying to make it look as clean as possible.
Thanks in advance!

 

[Bumbo]

I would (did) buy a small fuse block / distribution block and wire each individual accessory to that.

Each have their own protect circuit... same for my fridge, radio, solar charge controller...

One of those circuits is my "bumper plug" for my Noco charger. I did customize my plugs and changed them to Anderson quick disconnects.

 

[Tuc4R]

I would (did) buy a small fuse block / distribution block and wire each individual accessory to that.

Each have their own protect circuit... same for my fridge, radio, solar charge controller...

One of those circuits is my "bumper plug" for my Noco charger. I did customize my plugs and changed them to Anderson quick disconnects.

Yah, that’s what my Bussmann is for. I guess I’m looking to see how everyone routed their wires, and what they used.