03 to 05 fog/turning signal lights opening

[BigMike18]

Does anyone know how to get these open? I assume there’s no butyl holding them together and just little clips but want to make sure first

 

[BigMike18]

Does anyone know how to get these open? I assume there’s no butyl holding them together and just little clips but want to make sure first

Forgot the picture

 

[JVC8790]

There's just a clip holding the two lights together, if you're trying to split the lens off of the corner light only I believe its just butyl.

 

[hinmo24t]

not positive. just changed a bulb on one of the turn signals though..dual filament for 2004 amber DRLs. old bulb shattered in my fingers during replacement, i opted to not remove them for it, got it from the fenders liners.

You looking to retrofit the fogs or something?

good luck

 

[BigMike18]

There's just a clip holding the two lights together, if you're trying to split the lens off of the corner light only I believe its just butyl.

Trying to open up the light and spray the surroundings of the light black and not the bulb to match my headlights up top.

 

[Ed_C]

No clips, just sealer. This turn signal assembly was in pretty bad condition so I rushed taking it apart, ended up bending up the housing from excessive prying because I didn't heat up the sealer enough...

Not pictured is the plastic diffuser piece surrounding the bulb opening.

 

[BigMike18]

No clips, just sealer. This turn signal assembly was in pretty bad condition so I rushed taking it apart, ended up bending up the housing from excessive prying because I didn't heat up the sealer enough...

Not pictured is the plastic diffuser piece surrounding the bulb opening.

Thanks

What increments did you do for the baking? Temp? amount of time?

 

[Ed_C]

I used a heat gun, which was another reason I rushed it LOL. Unfortunately I don't remember how much time I spent.