3D Printed Tray Inserts
- Thread starter TiN
- Start date
preacher35
New member
TiN
New member
Alright guys, the first final product is here as requested by [MENTION=89791]preacher35[/MENTION] and [MENTION=93193]morphious[/MENTION] in [MENTION=50591]gaterose[/MENTION] 's thread Console Lid Compartment.
I figured it'd be easier for payment and shipping purchases to transact through my eBay, so here's the product page: Tissue Holder 4th Gen
As you can see, I do have returns enabled as these parts are still in development and haven't seen much real world use. If you purchase one and have any problems, feel free to let me know so I can make the necessary changes and replace the part.
I figured it'd be easier for payment and shipping purchases to transact through my eBay, so here's the product page: Tissue Holder 4th Gen
As you can see, I do have returns enabled as these parts are still in development and haven't seen much real world use. If you purchase one and have any problems, feel free to let me know so I can make the necessary changes and replace the part.
Pictures:
gaterose
Senior Member
That's really cool, but I personally would want something that could hold something other than a tissue box. Don't really have any exact ideas how it'd look or work though honestly...
Maybe make it deeper with a partition or two for pens, or just deeper in general so it'd hold a notepad without the pad sliding into the console immediately. When I say deeper, maybe I'm talking about length really... i.e. how far along the console lid it runs, not how deep the pocket sticks into compartment when the lid is closed. Seems like the other two dimensions are fine but it would hold other things better if it were 1/2-3/4 the length of the lid instead of 1/4
Maybe make it deeper with a partition or two for pens, or just deeper in general so it'd hold a notepad without the pad sliding into the console immediately. When I say deeper, maybe I'm talking about length really... i.e. how far along the console lid it runs, not how deep the pocket sticks into compartment when the lid is closed. Seems like the other two dimensions are fine but it would hold other things better if it were 1/2-3/4 the length of the lid instead of 1/4
TiN
New member
I think a combination of increased length, an upward angle, and a little lip on the compartment would larger stuff in there while driving. Very doable.
TiN
New member
I'll have a solid one done sometime this weekend and up on eBay, that's an easy change. Some like the logo and some don't, so I figured I'd do both haha. I don't know what's up with eBay's shipping rate, I'll have to check that :der:
preacher35
New member
TiN
New member
Yep, that's still in the works. I just got another 3D printer today, so I'll be working double time :artist2:
TiN
New member
It's about 9 x 5.5 x 5.25 inches. Anything bigger has to be sliced up into smaller printable pieces and then assembled afterwards.
TiN
New member
The front part is the bottom layer of the object when on the printer, and due to the nature of 3D Printing, the bottom layer is always going to be a little more rough than the rest of the object. I'll sand the next one a bit before vapor treating to see how it turns out. Haven't tried that yet :zoom:
preacher35
New member
SR_5runner
New member
Any chance you could print an Urban Runner Radio Trim Ring!? Assuming it wouldn't come out to a cost more than the exorbitant price dealerships charge.
