freeflight
New member
Good info, tag for later
Anyone know if it's possible to change just the driverside window to non-auto? It drives my wife nuts on her 4Runner. She can't seem to grasp the fact that it is a 2-stage button.
Just saw this post, one option would be to disconnect the battery and not recalibrate the driver's door. Not sure how long that would hold up though, it's not terribly hard to accidentally calibrate the window.
Another would be to swap window regulators with me since mine messed up and the auto function won't work anymore. But that would mean both of us being without a driver's window for a couple weeks.
Lol, honestly I just told her to figure it out! I think I'll try disconnecting the battery and resetting all the windows and then just leaving that one alone.
Please take no offense, but I think I'll keep the functioning regulator for now. Lol
Cheers
Hi guys, I am new here and I am having exactly same problem after I've blown the 140 ALT fuse along with 3 other ones, by wrong battery hook-up.....on my 05 SR5 v6 2wd 134k.I'm having a similar problem with my 4runner but following the steps doesn't seem to fix it. My AUTO light blinks constantly when driving, but never blinks when I follow the reset instructions. After the first reset attempt, I thought it was the LED, replaced the LED, didn't help (I know the LED wouldn't explain the auto function not working but I didn't think about it at the time and only noticed the blinking light). Bought a whole new switch assembly, connected it today, same thing. Tried following the reset after disconnecting and reconnecting the battery, the reset worked successfully for the sunroof and rear window, but I can't seem do anything with the drivers window. Any ideas what it could be? I tried the reset instructions posted here about 10 times before I gave up and posted this
My rear wiper/windshield washer fluid and rear defrost stopped working after i disconnected my battery.Yes, you need to reset the one-touch features on the power windows and moonroof when you disconnect the battery. The windows use less power to close these days (so they're less likely to crush hands or fingers), so they need to "remember" where the closed position is.
To reset the driver's side power window auto-close:
1. Push down and hold the driver’s door power window switch to completely open the window.
2. Pull and hold up the driver’s door power window switch until the window closes. Continue holding the switch for approximately one second until the switch changes from blinking to a constant illumination.
3. Check for proper operation of the “one–touch open/close” by pushing the switch briefly to the “DOWN” and “UP” positions.
To reset the moonroof one-touch operation:
With ignition switch in the “ON” position, do the following:
1. Push and hold the “TILT UP” side of the switch until the moon roof tilts all the way up and then tilts down slightly (approximately 10 mm [0.39 in.] at the rear).
2. Check for proper operation of the “one–touch slide open/close” and “one–touch tilt up/down” functions by pushing the switch briefly to the “SLIDE OPEN” and
“TILT UP” positions.
To reset the rear window operation:
1. Turn ignition switch to the “ON” position.
2. Push the back door power window switch to the “DOWN” side to open the window.
3. Push and hold the back door power window switch to the “UP” side until the window closes. Continue holding it for approximately 1 second.
4. Check for proper operation of the “one-touch open/close” functions by pushing the switch briefly to the “DOWN” and “UP” position.
The compass will also need to be reset if you disconnect the battery. Instructions for that are in the Owners Manual. You need to look at a map of the country to determine which zone you're in, and the instuructions are slightly different for 2003-2006 vs. 2007-2009.
Sunroof and drivers window does it too. Also, whenever I unplug my battery for a few hours to reset everything it usually stalls on the first crank and then fires up and runs fine.My rear wiper/windshield washer fluid and rear defrost stopped working after i disconnected my battery.
At the time i didn't thought it was related to the battery being disconnected.
I took my 4R to the mechanic shop. They waste 2hrs trying and checking everything.
When i came back it worked but they had no explanation of what caused the problem and what resolved it. They said maybe something was frozen or just a bad connection.
It cost me about 180$. Problem solved but i feared it will be back sometime.
That's exactly what happened about a month later. I disconnected the battery again and the problem was back.
I then realized it has something to do with the battery disconnection... But didn't know what.
I was about to take the 4R to a good shop specialized in electric problems. I was thinking about all the $$$ going out of my pockets again and i took a chance... What about a little Google search on that problem?
That's what i did and i just found this post and saying to myself "I couldn't be just that?". I ran to my 4R and followed the rear window reset instructions and guess what?
PROBLEM SOLVED! It only took 30 secs! You made my day!
You just saved me some $$$. I can't believe professionnals didn't find that, and that i paid 180$ for nothing...
This forum will be a must from now on...
Thanks again!