Swapped in a rebuilt MC, bled the heck out of everything, and it's still doing it. Brakes have always felt like they needed too much force, but I figured that was just crappy design. I can definitely feel the difference between engine off and engine on, so the booster is doing something, but even with the engine off, if I sit holding the pedal, it will go to the floor over 15-20 seconds. With the engine on and in gear, it's losing hold as it sinks, so sitting at a red light requires pressing harder until it just can't hold anymore and I had to use the parking brake to keep from rolling through the light.
I parked it on clean concrete, held the pedal until it was all the way down at least a dozen times, and no fluid visible anywhere. MC reservoir still full too.
Couldn't find a MC rebuild kit for it, but I went ahead and popped the C clip off the old one, pulled the pistons, and everything looks pristine: it's about two years old, (trying to fix the above mentioned needing more force and having more pedal play than pretty much everything else with modern brakes) and I see no wear or scoring on the walls, and even with some magnification, the seals look brand new.
Any thoughts on what would do this other than leaking MC seals?
I parked it on clean concrete, held the pedal until it was all the way down at least a dozen times, and no fluid visible anywhere. MC reservoir still full too.
Couldn't find a MC rebuild kit for it, but I went ahead and popped the C clip off the old one, pulled the pistons, and everything looks pristine: it's about two years old, (trying to fix the above mentioned needing more force and having more pedal play than pretty much everything else with modern brakes) and I see no wear or scoring on the walls, and even with some magnification, the seals look brand new.
Any thoughts on what would do this other than leaking MC seals?