coilover length

[berettashot117]

so ive got the toytec ultimate lift with 285/75/16's, and as expected I had some rubbing issues. I trimmed enough away to where it only rubs when I hit a bump while turning (ex. turning into my driveway). I've pondered about installing a 1 inch BL to solve this problem completely. however, I was looking at my coilovers today, and I notice it looks like I might be able to adjust it and raise it up a little bit higher. can anybody tell me if it's as high as it can go, and can I raise it a little more, hopefully solving my rubbing problem without the BL. thanks for any help

 

[berettashot117]

as much as I hate it, I need some help, so Saturday bump.

 

[zstampe]

as much as I hate it, I need some help, so Saturday bump.

I'm not sure how far you can safely go, but try turning each side about 5 spins then drive it and find out.

 

[zstampe]

Just looked at your pic closer. You have plenty of threads left

 

[berettashot117]

so, I don't have to use a spring compressor or anything, right? I can just use my special wrench and adjust it, right?

 

[Dawg4Runner]

How much over stock is your current lift? Where is it rubbing? You can lift your front up to around 3.5" over stock height. Anymore then you'll be stressing your CV joints. If you're rubbing on plastic then just trim more. If you're rubbing on the body mount frame then its time for a body mount chop. No amount of body lift will help you there.

Good luck, I know how annoying the rubbing can be.

 

[chaz]

send toytec an email with ur pic & ask their tech.