BlairB
New member
Wanted to post up my current set of drawer and fridge slide/enclosure. I had these made a few years back by a local cabinet maker. They are made primarily out of 3/4" ply and are very very sturdy. The drawer slides are 500 lbs lock-in, lock-out and allow the drawer/fridge slide to pull out 25". Currently they are held down by one side and one rear turnbuckle.
The entire thing was glued and screwed together so it is strong. The exterior was nicely sanded, but the stain was a quick job (and supposed to be temporary until I painted it) so it is nothing amazing.
These are coming out of a 4th gen 4Runner. I am sure they will fit a bunch of other vehicles and I can take any measurements not listed below if you need them.
Asking $275. Local pickup in San Ramon, CA.
Exterior Dimensions
Width: 41.75"
Depth: 28.5"
Height at Drawer: 15.25"
Height at Fridge Enclosure: 25"
Fridge "Tray" Interior Dimensions
Width: 18.5"
Depth: 26"
Photos (fridge and drawer contents not included
):
The entire thing was glued and screwed together so it is strong. The exterior was nicely sanded, but the stain was a quick job (and supposed to be temporary until I painted it) so it is nothing amazing.
These are coming out of a 4th gen 4Runner. I am sure they will fit a bunch of other vehicles and I can take any measurements not listed below if you need them.
Asking $275. Local pickup in San Ramon, CA.
Exterior Dimensions
Width: 41.75"
Depth: 28.5"
Height at Drawer: 15.25"
Height at Fridge Enclosure: 25"
Fridge "Tray" Interior Dimensions
Width: 18.5"
Depth: 26"
Photos (fridge and drawer contents not included
):
Last edited:
