Fuse tap help... Please!

[cheeser]

Curious to see if the empty fuse location below 10A ever worked out for a fuse tap? I'm looking to do add in a 12v line for a aftermarket BU camera and need powah.

Yes, worked for me.

 

[Bugser]

Spot #1 (which is blank) is +12VDC all times, 10 amps



Spot #2 is +12VDC controlled by headlight switch, 7.5 amps



Spot #3 is +12VDC with ignition, 7.5 amps



Instruction for the add a circuit are pretty obvious and are discussed by others in the last 5 years of posts in this thread, but I thought the above notes and below pic might be of assistance to others looking for a certain fuse output.

FYI
The 5th spot down on the right, that is blank, is 12v switched when the ignition is on


Sent from my iPhone using Tapatalk

 

[FourT6and2]

When you use one of the empty spots, do you need to add the second fuse to the add-a-fuse tap? Or can you just use the one for the new accessory?

 

[ElectroBoy]

When you use one of the empty spots, do you need to add the second fuse to the add-a-fuse tap? Or can you just use the one for the new accessory?

Just add the fuse to the tap location to supply power to your new circuit. Leave the other location blank.