Hi-Lift Jack Mounted Inside a 4th Gen??

[Canyonlands]

Do any of you have a Hi-Lift mounted inside your 4th Gen 4Runner? In a way that works either to remove for daily driving or that doesn't impact the cargo/passenger area for daily use (grocery getting, etc.)??

I have the 48" X-treme sitting here now wondering where it's going. I'd rather find some way to get it mounted inside than outside.

What I'm considering is two mounting locations.
1: For when the rear seats are in use. Probably below the rear seat cushion in a way that the jack would be just behind the lower legs of those sitting back there. I don't know what I'd be drilling through for a mount there but it would have to be sturdy.
2: For when the rear seats are folded flat. Haven't looked this over yet.

Any examples of an interior Hi-Lift mount?

 

[alex56]

I have mine mounted on my Sub box laying horizontally

 

[Canyonlands]

Thanks. This reminds me that it could be possible to mount a jack across one of the wheel arches.

Anyone mount anything through any of the interior surfaces mentioned?

I have no need to put gear on the roof and may as well keep the Hi-Lift off of it as well.

 

[magert54]

As a suggestion

I believe in things stored vertically, so have you thought of installing a mounting bracket to the roof (on the inside)?

 

[Colemanfu]

I run my rig as a flat bed 24-7. No little manfu's to pile in so I have mine on the floor behind the front seats. There was a time when I had it in the very back near the lift gate and use the 2 tie down loops to hold it in place.

This link should have a pix.

http://www.toyota-4runner.org/accessories/77965-anyone-done-any-hunting-modifications.html