How to replace 3rd Gen lower ball joints. Pic Heavy.

[roger65]

May as well post the video here too I reckon.

I'm going to be watching both the upper and lower vids today as I am doing my daughters 96 later on today. I checked with the local shop, they say 3.3 hours per side-so $600+ to the job-labor only, she already bought the parts.

BTW this 15 post thing really is a hinderance. 10 should be fine to weed out the goons.

 

[3bears]

cant read the above post....has timmys picture in the middle of it

so not knowing what was asked....yes use only toyota lower ball joints.
and simple tools make it easy unless your in a rust belt. The large and small pitman pullers from O rielleys makes the tie rod end and ball joint just pop off with little effort or damage....better than smaking with a hammer or using a pickle fork.
Torque specs are important...sure timmy lists them in his video

if your new to all this, watch his videos first

 

[Xinja_T4R]

nice write up!