Injector Question for 5vz-fe

[Cvett95]

I purchased the wrong injectors (23250-20010) for my truck and am wondering if they are compatible with a N/A 5vz? They are for the 3.0 engine in a van or Camry. 15cc more than stock. Any helpful input would be appreciated.

 

[19963.4lsr5]

The fuel trims should adjust for the extra flow.


Sent from my iPhone using Tapatalk

 

[Cvett95]

Thanks for the reply. Will be going for it tomorrow. Will report back.

 

[gamefreakgc]

I put in injectors that are 60cc's more than stock. ECU adjusted perfectly.

 

[tx_shooter]

I put in injectors that are 60cc's more than stock. ECU adjusted perfectly.

Have the part number for those injectors? Figure you did it for the supercharger?

 

[gamefreakgc]

Have the part number for those injectors? Figure you did it for the supercharger?

Yeah I used 23250-46030 from some Lexus/Supra models. But if you want to keep the engine's air assist fuel atomization, the "blue top Supra" injectors 23250-46050 are better. If I were to do it again, I would have put these in since they put out a spray instead of a stream.

 

[tx_shooter]

Yeah I used 23250-46030 from some Lexus/Supra models. But if you want to keep the engine's air assist fuel atomization, the "blue top Supra" injectors 23250-46050 are better. If I were to do it again, I would have put these in since they put out a spray instead of a stream.

Great timing! I plan to spend a weekend this summer taking my S/C off and servicing the nose cone, fuel system, and such while I am in there. Injectors have been on my mind since my rig has 340k miles on it now.

 

[mtbtim]

Great timing! I plan to spend a weekend this summer taking my S/C off and servicing the nose cone, fuel system, and such while I am in there. Injectors have been on my mind since my rig has 340k miles on it now.

I don't know if you are familiar with our channel, but we have several videos that will help you with your planned work.

<iframe width="560" height="315" src="https://www.youtube.com/embed/7RmHXvEQwXs" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe>

<iframe width="560" height="315" src="https://www.youtube.com/embed/56KhWJPUevk" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe>

<iframe width="560" height="315" src="https://www.youtube.com/embed/N-lhZIWOkyU" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe>

 

[tx_shooter]

[MENTION=120071]mtbtim[/MENTION]

Oh yeah I have watched more than a few of the videos. One of these days I hope you do one on replacing the bearings on a 3rd gen 4R / 1st gen Taco front spindle.

 

[mtbtim]

[MENTION=120071]mtbtim[/MENTION]

Oh yeah I have watched more than a few of the videos. One of these days I hope you do one on replacing the bearings on a 3rd gen 4R / 1st gen Taco front spindle.

I just posted about this in another thread I started. We do have two videos that will help you get it done. Here's a link to that post: https://www.toyota-4runner.org/3461582-post29.html