Chuckles89
New member
After searching for a while, I found this link The "Two-Low" mod - TTORA Forum and read through all four pages. It was pretty confusing and I figured it out. If you want low range rear wheel drive without doing a manual hub swap, here is what you do:
There are two sets of wires that go into the transfer case on the driver's side and on the passenger side. These have a blue plastic plug. On the passenger side, cut the yellow/black wire and put in a switch or a quick disconnect. This will trick the ADD system to think the transfer case is in 2-Hi when the circuit is broken. On my truck, the plug was cut out and the wires were twisted together. I soldered the blue one back into place.
To use 4WD, just re-connect the wire.
I hope this helps someone do this awesome mod!
There are two sets of wires that go into the transfer case on the driver's side and on the passenger side. These have a blue plastic plug. On the passenger side, cut the yellow/black wire and put in a switch or a quick disconnect. This will trick the ADD system to think the transfer case is in 2-Hi when the circuit is broken. On my truck, the plug was cut out and the wires were twisted together. I soldered the blue one back into place.
To use 4WD, just re-connect the wire.
I hope this helps someone do this awesome mod!
