LR UCAs installed - Where to set balljoint for initial CAMBER???

[STLDAVE]

I just finished installing a set of 5100s with the Toytech coilovers in the front and SAW coils in the rear. I also installed Light Racing UCAs. :bravo:

I've seen some postings about where to set the UCA ball joint for the CAMBER (not caster) for the initial set up before I take it to the alignment shop. It seems like I remember it being 1/4 inch from being fully to the outermost position, but I can't find that info now.

Can anybody help?

 

[limamike]

Courtesy of Harper7: http://www.toyota-4runner.org/5th-gen-t4rs/111733-icon-stage-1-installed-but-3.html#post1024966

 

[STLDAVE]

Courtesy of Harper7: http://www.toyota-4runner.org/5th-gen-t4rs/111733-icon-stage-1-installed-but-3.html#post1024966

Thanks LM, that's the one I remembered.

 

[mikey's2010SR5]

My vote or advice would be have the camber plate set at 0° which gives 2° of additional caster then have the camber plate slid all the way out.

 

[2010riddle]

Any pics or feedback on the new setup? I was interested in this same combo so curious to see how you like it :tongue:.....

 

[STLDAVE]

Any pics or feedback on the new setup? I was interested in this same combo so curious to see how you like it :tongue:.....

Getting the alignment Wednesday morning. I'll post some pictures and comments after I get a few miles on it.