On-Board-Air Setup. Quick check?

Krayziekid · 2015-12-02T22:14:58+00:00

Hey everyone. So I am in the process of gathering things for my on-board air setup and I was hoping someone could check my thinking before I take the plunge and forget something important. Here is the parts list I am currently looking at: -ARB Twin Compressor -80A Circuit Breaker (To go between the compressor and battery) -4Ga or 6Ga wiring for said circuit breaker I'm also gonna get the pump up kit too. I already have the air gauge, so that should be the last thing I need. Is there anything major/vital I am forgetting in this setup or anything I need to change? Thanks!

Thread starter Krayziekid
Start date Dec 2, 2015

Land Shark 1971

Junior Member

Dec 7, 2015

Krayziekid said:
My question revolved more around the illumination on the switches as opposed to the compressor itself. I am going to be running it so that it only works when the car is on, but I appreciate your insight anyway!

Roger that! I ran both the illumination and control part straight off my fuse panel. I know others have tapped into existing circuits so that it only will run while started and the switch is only illuminated while lights are on.

Good Luck! I love my ARB very convenient!

Post up when you have it all complete