S SDHNTR New member Oct 10, 2011 #1 I damaged my prop shaft removing a u joint. Found a used slip yoke on Ebay. Can I just slide this one into my existing driveshaft? Or is that a bad idea?
I damaged my prop shaft removing a u joint. Found a used slip yoke on Ebay. Can I just slide this one into my existing driveshaft? Or is that a bad idea?
Hyde802 New member Oct 10, 2011 #2 Should be fine. But youll want to get it balanced at a drive line shop.
S SDHNTR New member Oct 10, 2011 #3 U really think just the yoke would make the whole thing need balancing? It's just the front flange that I damaged. Should I just pull the flange off the new part and install it on my existing driveshaft with a new U joint?
U really think just the yoke would make the whole thing need balancing? It's just the front flange that I damaged. Should I just pull the flange off the new part and install it on my existing driveshaft with a new U joint?
fourwd1 Moderator Oct 14, 2011 #5 Just make sure you install it so the yokes on each and are in the same plane, or you will have vibrations.
Just make sure you install it so the yokes on each and are in the same plane, or you will have vibrations.
