So Cal 4Runner BS Thread
- Thread starter TK-422
- Start date
violation
Member
yea, the idea would be camping and soaking in the natural beauty.
Oneluv13T4R
New member
Isn't duralast from autozone?
RyanEJ25
New member
Brake pads? Yes for my beater Honda. No on my 4runner. I'll use ebc pads on the 4runner.
SoSoRunner
New member
Installed my LED light bar onto my bull bar and wired up the mictuning switch/ harness. It was pretty straight forward I ran the wires through the rubber boot next to the master cylinder.
Also getting my Demello sliders/ body mount chop welded up today. Had to remove the stock side steps and all the XREAS lines, I will post more pics after they're all welded up.
Also getting my Demello sliders/ body mount chop welded up today. Had to remove the stock side steps and all the XREAS lines, I will post more pics after they're all welded up.
violation
Member
ah yea, probably. i was looking on their website too. but that kind of generic stuff is ok?
what about rotors and calipers? are better pads even necessary for a 3rd gen upgrading to Tundra brakes? i figure even the generic stuff will be leaps and bounds better than what I currently have, even if it's toyota oem.
cbr900boy
New member
I put Akebono pads in my wifes lexus. They are just as good if not better than orm for almost half the price. Look them up.
MACT4R
Senior Member
Doing the TBU is a great upgrade. I just got done with mine about a week ago and such a difference. Cleaned and painted mine using Por-15. I lucked out and got everything in the junkyard but run centrics rotor's and pads on the 4th gen and lexus. Been happy with it so far. Got it at rockauto.
RyanEJ25
New member
I think brakes are more of a personal preference based on past use kinda like tires. I used EBC because of my Subaru's and I think I used red stuff pads. I like the warranty on duralast pads if they crack they replace them. Just dont buy drilled rotors. They suck, have no benefit and can crack.
MisterNickG
New member
Had a chance to install my spacers and my 32" LED bar in the grill
Before
After
Sent from my SAMSUNG-SM-G890A using Tapatalk
Let's see the grill!
SoSoRunner
New member
Installed my LED light bar onto my bull bar and wired up the mictuning switch/ harness. It was pretty straight forward I ran the wires through the rubber boot next to the master cylinder.
Also getting my Demello sliders/ body mount chop welded up today. Had to remove the stock side steps and all the XREAS lines, I will post more pics after they're all welded up.
Updates!!!!!!!!!!!!! :whoo:
Before sliders went on, ohhhh so clean without any sides.
Making sure they're level before tacking them in place.
Final welding
Lift test from sliders, Mmmmm flexy!
Shout out to @b1_jo if anyone needs a full length room rack or some welding services hit this guy up, super professional! :cheers:
SoSoRunner
New member
Pm'd you back man! Yes then Joe's racks are what you're looking for. If you pickup just a bare rack (raw metal finish) with no options like wind deflector, light bar mounts, or sunroof cutout it will be very affordable!
mwray8909
New member
SoSoRunner
New member
Of course, info was pm'd!
