Some issues post atermarket radio install...

[DK327]

So I decided to upgrade the stock radio on my 00 T4R. Everything went well with the install and the new radio works fine but I noticed post install the turn signals, clock and back window are all not working. Any help is much appreciated. I did disconnect the negative battery terminal before taking everything apart...

 

[Tucson4runner]

Clock and back window could be from the plugs not being correctly attached to the trim piece around the radio. I know there is a "dummy" plug back there that doesn't connect to anything and its just below where the harness actually needs to be plugged into. As for the turn signals I have no idea. Check your fuses and see if maybe some wires crossed when you turned the truck on and shorted something.

Sent from my SM-N910V using Tapatalk

 

[Doc2012]

Clock and back window could be from the plugs not being correctly attached to the trim piece around the radio. I know there is a "dummy" plug back there that doesn't connect to anything and its just below where the harness actually needs to be plugged into. As for the turn signals I have no idea. Check your fuses and see if maybe some wires crossed when you turned the truck on and shorted something.

Sent from my SM-N910V using Tapatalk

Turn signals could be because the hazards aren't hooked up.

They won't work if the hazard switch is disconnected.

 

[fblainen11]

You didn't connect the plugs correctly.

 

[DK327]

Thanks for the responses all, as it turns out, I had the whole top cluster unplugged... Probably put everything together temporarily to see if the radio would work and forgot that i didn't plug everything back in... Thanks again!