Bleeding brakes is easy. I would budget for 3 bottles of brake fluid (36oz) or 1 litre.
1.) Take a damp rag and clean the brake fluid reservoir cap and the reservoir near the opening so you don't get dust or gunk going in
2.) sipon, suck, syringe, whatever to get all the old brake fluid out of the reservior
3.) open a brand new bottle of brake fluid and fill to max (never use brake fluid that has already been opened)
4.) set car to "on" but engine not turned over. So it goes off -> acc -> ON (but don't turn engine over)
5.) start at back of car, passenger rear. Put clear brake hose on nipple, hose goes to a bottle, open bleed with a flared wrench (if you live in rust belt, this is important else you could be in for a brake caliper replacement as well).
6.) depress the brake pedal with the bleeder open about 25% of travel. The ABS pump will activate and push brake fluid out. Don't hold pedal for longer than 5 seconds at a time until you get a feel for how fast the fluid is coming out. Don't let the reservior go below MIN. The ABS pump moves a lot of fluid out very fast. I would budget about 75% of a bottle for this one side.
7.) Close bleeder, wipe the bleeder with a paper towel.
8.) Move to driver rear, and redo #4 to #7. Always making sure the reservoir is above MIN. I'd budget 60% to 75% of a bottle of brake fluid for the driver's rear
9.) close bleeder, wipe etc etc
10.) Move to passenger front, put hose on, crack bleeder, and let it slowly dribble out. This is the Gravity Bleed method. The SCCA guys swear by this method. I do it this way for 10+ years now. I'm also not being paid or on the clock. Budget 30% to 50% of a bottle for passenger front.
11.) close bleed, etc etc,
12.) Move to Driver front (make sure reservior is full). Crack bleeder, let it dribble out. Spend about 25% to 50% of a bottle here.
13. Close bleeder... done.
The reason why you use less and less as you go around the car as fresh brake fluid has already made it's way around.
You can pump and open bleeder etc if you have 2 person. If you are solo, then it's pretty much gravity bleed, or you find a vacuum bleeder etc. I've always used Gravity, and it helps prevent you from over traveling your master cylinder. The bore of the master cylinder usually wears over time or has build up. As you go max pedal travel the piston seal rides over this ridge and you end up damaging your master cylinder and have an internal bypass leak. With Gravity bleed you never encounter that.
Also don't ever let your master cylinder go empty. To bleed a master cylinder is not so trivial on modern cars.
Good luck.