Toytec adjustable coilovers - how many threads for two inches of lift?

[High_Country]

I screwed up. Wheelers off road is closed today (every Friday) and toytec is closed.
I purchased the toytec 'ultimate' adjustable coilovers based on the bilstein shock.

I have the front disassembled and getting ready to put them in BUT I don't know what lift height they're set at OR how to get the height I want. Again these are the ADJUSTABLE coilovers with the threaded collars and spanner wrenches.

I want two inches of lift.

Any help would be GREATLY appreciated.

Thanks!!!!

 

[Jeremy556]

It depends.

Install them, drive around a bit to settle, adjust from there to your liking, and get it aligned.

 

[manofsteele2003]

It depends.

Install them, drive around a bit to settle, adjust from there to your liking, and get it aligned.

Yeah I've heard the same, you'll set them where you want then after driving around a bit they'll settle and you'll have to readjust before aligning.

 

[High_Country]

Well, got everything on - front and rear. I'm hoping the front springs settle!

I had approximately 1 inch of threads below the adjusting collar. I ended up with what appears to be about 3-1/2 to 4 inches of lift. Holy crap...



Any experience with how much the springs will settle?