What did you do to/in your 5th Gen today?!

[Kashoggio]

Ordered...

Wolfgang Uber Ceramic complete kit


C&R Racing Transmission cooler and a Hayden mounting kit

Then mounted my freshly powder coated C4Fab sliders...arty:

Wolfgang is fantastic

 

[WallyT4R]

Wolfgang is fantastic

I found it through your build thread...thanks!

 

[Satex]

I have the techstream software and cable.. i live in so cal also we should meet up and try it.. there is a program new key wizard.. check it out on youtube.. is the key cut?

Yes it's cut but chip and the fob don't work. I'll try the dealer first since I just purchased the vehicle two weeks ago.

 

[calcrc]

2 Days ago..... did this !

 

[96706RROMJP]

Installed my retrofits!

 

[John-West]

Alabama Hills Just outside Lone Pine CA - looking east.
Mt. Whitney not visible due to clouds. Rare to see snow on the ground here.

 

[Maadcaap]

Yes it's cut but chip and the fob don't work. I'll try the dealer first since I just purchased the vehicle two weeks ago.

You have to program the chip in the key.. it should crank the motor but it wont start untill you program the chip to the immobilizer

 

[EL3V8TE]

Installed my rear led lights on my Gobi rack and ordered my rock sliders!


Sent from my iPhone using Tapatalk

 

[Boba_Fox2015]

First time poster here! Got my SCS Stealth 6 and BFG KO2s put on yesterday!

 

[jjolles]

2017 TRD Pro Cement - Blackout

Blacked out the emblems on the rear door.

 

[Discovery]

Baby is due I less than 2 month so I test fitted everything to see how it goes.

Jogging stroller, trunk organizer with tools and full size Malamute.

Baby seat installed, with husky liners

Happiest Malamute in town!

Drive around with back window open for the first time, really nice! Dog like it, people stare at him!

 

[RodRunner]

Cleaned up my tailpipe...

 

[atchcraft]

Recovery hitch

I had an old stinger laying around, so I decided to put it to good use. Gave me a chance to fire up the welder after a few years of collecting dust.

 

[zefram47]

Did my first tire rotation with the Falkens. Amazing how much heavier these tires/wheels are than even my STi's were. The Miata's tires/wheels are around 30 lbs combined...pretty sure the 4R's are closer to 75 lbs. Also, even without a lift, one of my jacks maxed out on the axle and needed a hockey puck just to get the tire off the ground. Used the spare to make a rear-cross rotation take a few less steps.

I know that the spare doesn't have a TPMS sensor, but does anyone know if the TPMS computer will accept a sensor for the spare? I'd love to get another TRD wheel and toss the spare into the rotation, but don't want to forego the TPMS functionality to do it.

 

[Ray Dunakin]

A guy with a Nissan X-Terra came over and complimented my 4Runner when I was at Vons today. We had a nice chat about off-roading.

 

[R4nnerR4nner]

Finally ditched the dealer tires and got some Cooper AT3s installed. I'd share a picture if it wasn't raining so hard that we have flash flood warnings..

 

[rokmoso]

went snowboarding today..MT HIGH!

 

[flying fuzz]

Nice quiet drive exploring some logging roads.

 

[J - S&C Coach]

went on my first snow adventure... epic https://vimeo.com/200621526


Sent from my iPhone using Tapatalk

 

[Kneesamo]

Visited the snow again. It's such a rare occurrence that I have to take maximum advantage of it.

4Runner by Benjamin Scott Cook, on Flickr