What did you do to/in your 5th Gen today?!
- Thread starter DEKA3
- Start date
2016 4Runner SR5
Senior Member
Put them on now. You don't need a lift to run them.
Northern 4Runner
New member
I know, but the lift is in my basement and I want it all done at once. But it's nice to know they fit stock.
2016 4Runner SR5
Senior Member
285/70/17 stock, no lift. Had very little rub only in reverse which turning sharp. There's a lot of room for bigger tires under our trucks.
Attachments
KWSRStorm
New member
I have them on stock. Only rubbing at full lock reverse going down a hill. If you have to wait a decent amount of time for the lift to go on just put the tires on. If its not too long do it all at once. I had to get an alignment after i had mine put on (but i got new wheels too so maybe that was part of it)
Sent from my SM-G930V using Tapatalk
greatape
Senior Member
Nice! Think I will be going with same cage in the future. Like the design compared to others.
Have fun on the trip and look forward to some pics...
A10MileHusker
New member
Thanks!
Ya I really like this design and the fact that I don't have to move any engine components. I know SW has a perfect set up and its an easy conversion but I would just rather not mess with relocating anything. Looking forward to receiving it and getting it installed.
Went on dirt the other night. Complete difference between the light bar being attached via zip tie to the grill and this bracket mount. The light shake is 99% gone and the brackets held up fine.
ayeyothisiskyle
Member
I installed my ditch lights last night and noticed the stock punchout buttons (i.e. dash backlight control, A/C button, windshield wiper heater) only fit in the punchouts they are in. I wanted to move the dash dimming wheel down next to the wiper heater button, but there are "teeth?" (channels) specific to each button/punchout slot.
Wondering if anyone else has run into this.
Wondering if anyone else has run into this.
singletrackftw
New member
Family picnic in payson
Nature pocket dump.
Must be a glitch
OME 895E/883 + Bilstein 5100 | GOBI stealth | RCI alum front skid | FN Countersteer X | BFG 265's | AVS hood visor | morimoto HID's
Nature pocket dump.
Must be a glitch
OME 895E/883 + Bilstein 5100 | GOBI stealth | RCI alum front skid | FN Countersteer X | BFG 265's | AVS hood visor | morimoto HID's
CRFofiddyF
New member
I did when installing my LED bar/pods switches. I had to do some trimming
Northern 4Runner
New member
ayeyothisiskyle
Member
Basically just open up the channels?
Ljlittlej
New member
I'm sure to get a lot of backlash on this one...but still wanted to see what the community thought...So I put the billet grille on the front of my trd offroad. Similar to the grill you see on the xP. Looks a bit better in person, but I think you get the idea from the pics. I personally like the way it ties in the lower valence, but I still want to gunmetal paint it soon.
Attachments
Last edited:
aelarson
New member
Not my vibe, but I respect it because it looks clean and flows with the truck nicely! Also different than most the T4R's on the forums! :hatsoff:
ADK Explorer
New member
I hope your significant other was able to help you with that. lol
Similar threads
