DannyLlama
Elite Member
Which wheels are those?!
What did you do to/in your 5th Gen today?!
- Thread starter DEKA3
- Start date
Which wheels are those?!
DallasTRDPro
Member
Thats genius!!
anomalous
New member
TRD PANTHER
New member
I have to agree with both of you. I had a 1.5/1" cornfed spacer lift added to my Pro 20 months ago with 275's. Had 285-70-17 Falkens installed 2 months ago and it doesn't look as lifted as the tire fills the wheel well more.
anomalous
New member
Wow, didn't have any issues with clearance for the 33s at 1.5F/1R ? I'm guessing was on the stock TRD Pro 17x7 +4 wheels ?
TRD PANTHER
New member
Yes. No mods what so ever. Remember, the Pro is 1” higher up front then all the other 4Runners. My center of hub to top of fender arch is 22.5” front, and 23.25” rear.
The bottom pic is with 275’s.
Attachments
Last edited:
Crikeymike
Senior Member
Welcome to the club!!! :cheer2:
LakeRunr
Member
Pulled my utility trailer out of a ditch & brush 10 feet off the road with the 4Runner and a snatch strap. Why? Funny story. Because some a-hole stole the trailer last night from where I had it parked. He cut the lock and hurriedly hooked it up to his van (I have video of it). But, he didn't make it a mile down the road before he hit a dip in the road, which caused the unretracted "foot" of the trailer to hit the ground and pop the tongue off of his possibly-too-small ball. He also hadn't hooked up the safety chains, so the trailer pulled the inanimate-object equivalent of jumping out of a kidnapper's moving car. It took a left turn into the only soft spot around -- a patch of kudzu and mud. The police had a report of a trailer "in the woods" from this morning when I called in the theft.
Happy ending...the trailer was muddy, but not damaged. Thieves suck.
Happy ending...the trailer was muddy, but not damaged. Thieves suck.
Last edited:
SR52011
New member
Love the look! What center caps came with the wheels, do you have them on, its little hard to see.
anomalous
New member
Thanks ! Not running center caps, but the wheels came with color matched flat disc center caps
Gamma Ray
Banned
Is that the one from Antics? I have one, too. It's good, but I had to take a hair dryer and warm up the plastic hooks to reshape them a bit so they held on the fuse box better. I woke up one morning to find it had fallen, but it was fine after I pulled the hooks in just a little bit.
TRUSTYAXE
New member
Yes that’s the one. Once I busted a few tabs off to accommodate my 4 add a circuit fuse holders :rockon: it went right on no problem. My stock one has been Velcro'd to the side for some time now and I came across a post about these. Looks like some 3d printed nonsense but it worked and was cheap.
Beyond that I ordered my OEM sliders and [MENTION=164250]Caliraisedled[/MENTION] ditch light kit....finally.
Last edited:
rhadam
New member
Installed Tacotunes dash + front door speakers. Overall the install was simple despite having no previous experience with audio installation. Hardest part was getting the speaker wires from the dash down in to the footwell where you wire in the crossover. Sound is much improved over stock for what I consider to be a pretty reasonable sum of money. BUT.. it needs an amp to really shine, that much is obvious. If the CarTrimHome T9 ever comes back in stock i'll probably do that first, then amp. Overall, very happy I did this.
SR52011
New member
Thanks for the reply! Bronze is a great color. I have factory wheels now with a 2.5/1.5 lift. Are you rubbing any at full turn? Did you have to modify anything? I am looking at some 17x9 -12 with 285/70 is why I ask. Buy may go with +1 offset so I wont have to do a BMC.
Last edited:
MyNew4Runner1
New member
Finally switched out the stock duelers for a new set of falken wildpeaks...she finally looks like a real truck now 
20h4Runner
Member
nice wrap!!!
Similar threads
