cmilviper
New member
Look's great man!!
It appears that your fender is still in line with the door........after the recent off-road activities & offset change/fender mods!
What did you do to/in your 5th Gen today?!
- Thread starter DEKA3
- Start date
Look's great man!!
It appears that your fender is still in line with the door........after the recent off-road activities & offset change/fender mods!
Mutant138
Banned
It actually got pushed out a bit on the drivers side. More chopping and spacing ahead.
Blue 4ever Runner
New member
Looks really good, nice job.
Scowling Tuna
New member
Love it. Are you planning on using the factory washer bottle? And is the secondary air pump filter, is that for an aftermarket compressor or something engine related?
Mutant138
Banned
Factory bottle is a silly shape but I will reuse the stock pumps. Not sure what route bottle wise I'm going yet. Prob just going to grab something at an autoparts store. Maybe a tacoma res?
"An air pump, also commonly referred to as a smog pump, is an emissions component that is part of the secondary air injection system. It is responsible for pumping clean air into the vehicle's exhaust stream to promote a cleaner and more complete burn before the fumes exit the tailpipe."
Might just be the only air pump. Not sure why I'm calling it a secondary. Anyways, oem foam filter is known to fail in the past on some yotas. Just some insurance to swap it out.
Last edited:
pDubs
New member
Yup, I did the secondary air pump filter about 2 years ago. I plan on just replacing the filter with the engine and cabin filters every 30k miles.
Little write up on Trail4r
Secondary Air Injection Pump Mod on 5th Gen 4Runner, Air Pump Filter
Also, these weren't included in the earlier 5th gen models. They started in 2013.
Little write up on Trail4r
Secondary Air Injection Pump Mod on 5th Gen 4Runner, Air Pump Filter
Also, these weren't included in the earlier 5th gen models. They started in 2013.
Last edited:
scottfromindy
New member
oljedi11950
New member
Cut up my bumper the other day
May one ask what you used to do the trim ? Very clean
I just had it sitting in there.
blksubykid
Member
FJToyman has the best rear shock skids IMO
SpeedyKevin
New member
Installed RCI’s rear shock guards. Not 100% stoked on the slot design for the rear shock bottom bolt... but I think it’ll be ok.
Sent from my iPhone using Tapatalk
I have a set too and so far they have been fine but yea wasn't the biggest fan of the slot design.
ESPDTRD12
New member
Bought some new 285 70 17 BFG KO2’s that replaced my Goodyear Duratracs after 45k miles. Duratracs were a great tire however, they began to get really noisy and making my TE run a little rough. Also swapped out my RIGID D2’s after 5 years of usage to these amber knock off’s from Amazon. So far so good!
Brick Sprickly
New member
Haven't posted in awhile but not for a lack of activity. Been travelling all over WA and into OR the last few months. I have tons of pics but let them collect to the point where it'll be a project to sort/upload them all haha.
Finally hit 25k on the odo so ordered a replacement engine air filter and swapped that out for the K&N classic washable. Might upgrade to the CAI one day but that's down the mod list.
Going to head up to Fort Worden tomorrow and hike there with my dog, then on the return trip go finally explore a little of Tahuya ORV Park which I keep neglecting.
Finally hit 25k on the odo so ordered a replacement engine air filter and swapped that out for the K&N classic washable. Might upgrade to the CAI one day but that's down the mod list.
Going to head up to Fort Worden tomorrow and hike there with my dog, then on the return trip go finally explore a little of Tahuya ORV Park which I keep neglecting.
Similar threads
