What Did You Do To Your 3rd Gen Today?

Status
Not open for further replies.
How hard was it to remove those control arms !? I heard they r a pain...

I didn't think it was too bad at all. Three jaw puller that I rented from autozone made quick work of separating the upper ball joint post from the upper control arm. I think separating the upper ball joint from the knuckle is the painful part but I didn't have to do that
 
Finally got my cargo area bike rack all bolted up. Used a piece of 2 1/4x1, a fork block I got off amazon, and nutserts(or rivet nuts, whatever you wanna call 'em).

scw5yVJ.jpg


hN3h5ww.jpg
 
So I swapped out my CV axles for a set of rebuilt Toyota units.



For the life of me I can't get the boot normal. Any tricks?




Am I going to run into the same problem of the boots tearing?



Should I stretch them?

 
So I swapped out my CV axles for a set of rebuilt Toyota units.



For the life of me I can't get the boot normal. Any tricks?




Am I going to run into the same problem of the boots tearing?



Should I stretch them?



I would think you are OK. Those are some heavy duty boots. Manufacturer?

What is with all the anti seize? Rust prevention?
 
Finally got the black satin krylon paint to refresh all the black interior plastics.
I'll never going to use rustoleum again.
 
How many mods will ya have to do to make it fit properly?
Same snorkel I'm gonna have. Its an easy install and it doesn't require the taco intake tube (I have 2 for sale btw if anyone plans on running an arb snorkel)
 
Last edited:
Status
Not open for further replies.

Members online

No members online now.

Forum statistics

Threads
278,316
Messages
3,554,120
Members
248,016
Latest member
Advally Service

Trending content

Back
Top