What Did You Do To Your 3rd Gen Today?

Status
Not open for further replies.
Come on guys, let's not get out of hand. The ACLU just retired the word dummy. Stop the hate.
 
Last edited:
Hammered my pinch welds today

ef101bd8eca3e5a3c235c9690bdf5077.jpg


5a6d22c40e3895322bfa69dae7171439.jpg


I primed them, but didn't get a shot of it
 
Teaser Pic



Didn't get much done on the 4Runner... had to dig a huge trench by hand today to run a gas line into my house... helped swap out some electrical, sold and moved a home fuel tank, and then buried my trench. :whipping2

Plan is to put the truck together tomorrow afternoon or after dinner.... hopefully! :canada:
 
I put on some new Wade window reflectors and installed new PIAA bulbs. What a difference they make, so much brighter than the ones in there, they looked OEM. Very happy so far.

Just have to figure everything else out now.
 
alignment and balance wheels/tires. ordered some OE parts. picked up another steering wheel and license plate finish panel and installed new OE lamp assembly.
20150528_123324[1].jpg

20150528_123643[1].jpg
 

Attachments

  • 20150528_123324[1].jpg
    20150528_123324[1].jpg
    135.6 KB · Views: 792
  • 20150528_123643[1].jpg
    20150528_123643[1].jpg
    137.2 KB · Views: 733
Changed cv boots on the left side using kballs excellent write-up, modified to accommodate manual hubs and matching cv shafts. More grease than even I want to wallow in.
P5287193_zpsk5klqb6z.jpg~original


P5287192_zps8ffduumw.jpg~original


P5287190_zpsd4c1gnui.jpg~original



While I was in there I found this in the hub...
P5287177_zpsdwvjhraa.jpg~original


Here a lot of it's been cleaned out, you can still see some though.
P5287175_zpsiodqdjdy.jpg~original


If anyone can elaborate on what's going on here I'm all ears...manual hubs out of a 96 Tacoma...all I know is bad news, bear.
 
Leveled

While I continue pondering the direction I wish to go with my lift/tires I decided to raise the front an inch in order to level it out a bit front to back.

I also took the grinder to my front skid when I had it up on the lift... While I was under there I noticed my LCA was contacting the skid and actually limiting my down travel. Had to take about 1/4" off of it on both sides.

Before:
oD12CvVl.jpg


After:
w80nxoVl.jpg
 
While I continue pondering the direction I wish to go with my lift/tires I decided to raise the front an inch in order to level it out a bit front to back.

I also took the grinder to my front skid when I had it up on the lift... While I was under there I noticed my LCA was contacting the skid and actually limiting my down travel. Had to take about 1/4" off of it on both sides.

Before:
oD12CvVl.jpg


After:
w80nxoVl.jpg


Do you normally run with all that weight on the back with the tent etc? I actually like a good bit of rake in my vehicles, but i could see it being too much if you were to take the tent off and the back comes up a bit. She looks great either way though.
 
Status
Not open for further replies.

Members online

Forum statistics

Threads
278,316
Messages
3,554,120
Members
248,016
Latest member
Advally Service

Trending content

Back
Top