What did you do with your 4runner today?
- Thread starter NorthGa4R
- Start date
kevinpt
Senior Member
info on mounting of the hella lights you have. i got a pair of lights the other day and looking for some mounting ideas
Slowgoat
New member
Added the right side audio controls for the steering wheel.
Installed the remote PAC steering control for the Kenwood deck.
Worked the first time, that's always a big plus!
Replaced the blower motr that was chirping with a new denso unit. (the old one was a denso, too which worries me. It had 11-14 written on it. Makes me wonder . . . )
I'll just keep my fingers crossed this blower motor lasts. They aren't cheap.
Installed the remote PAC steering control for the Kenwood deck.
Worked the first time, that's always a big plus!
Replaced the blower motr that was chirping with a new denso unit. (the old one was a denso, too which worries me. It had 11-14 written on it. Makes me wonder . . . )
I'll just keep my fingers crossed this blower motor lasts. They aren't cheap.
guardsred944s
New member
Sweet thanks! I'll do this next week.
Rocket61
New member
With?
Slowgoat
New member
What did you go with?
LTDSC
New member
Visaton FRS7-4 2.5" Full-Range Speaker 4 Ohm
They're smaller and don't mount where OEM does. I mounted them directly to the bracket the OEMS mount on. I just cut the wires and soldered from the originals to these ones. Sounds great to me, a ton more clarity and really makes the center channel liven up.
Last edited:
Rocket61
New member
Visaton FRS7-4 2.5" Full-Range Speaker 4 Ohm
They're smaller and don't mount where OEM does. I mounted them directly to the bracket the OEMS mount on. I just cut the wires and soldered from the originals to these ones. Sounds great to me, a ton more clarity and really makes the center channel liven up.
So no additional hardware required for mounting?
LTDSC
New member
None. I did a pilot hole into the bracket that holds the speaker after marking the guides. It sits good and flush with the door panel as well when installed. I mounted them in the bottom of that bracket. With the wiring up.
This is with stock jbl amp for the door speakers.
Rocket61
New member
Hmm sounds pretty straight forward. I'll probably order these in the next few days. Thanks LTDSC!
LTDSC
New member
I was shocked how easy it was to be honest.
Doozi
New member
I raised the front end to see if I could reduce the rubbing... what a difference an inch makes! It actually ended up 1.063" higher and it only rubs on the passenger side at almost full-right lock now. I still need to get an alignment, but feel that I've made some good progress! The bottom edge of the front fenders are now sitting at 38-11/16" from the ground... seem about right?
emelianenkov
New member
Took it to the gun shop and picked up a new toy 
Slowgoat
New member
Visaton FRS7-4 2.5" Full-Range Speaker 4 Ohm
They're smaller and don't mount where OEM does. I mounted them directly to the bracket the OEMS mount on. I just cut the wires and soldered from the originals to these ones. Sounds great to me, a ton more clarity and really makes the center channel liven up.
Cool man. Easy smeezy.
OzarkRunner
New member
Similar threads
