2013 shark fin question

[cmguss]

I'm looking to run coax from two additional antennas I'm mounting to my Gobi roof rack into the back of my truck. Within the shark fin, is there enough room to drill two small holes for RG58 coax and run two cables, using grommets installed in the shark fin and then through the roof? I'd like to do this if possible to add a bit of protection from leakage. I've searched these forums and the Internet for photos of the inside of a shark fin without finding any. I assume a portion of it may be hollow and unused.

Thanks!

 

[eddiebx]

I'm looking to run coax from two additional antennas I'm mounting to my Gobi roof rack into the back of my truck. Within the shark fin, is there enough room to drill two small holes for RG58 coax and run two cables, using grommets installed in the shark fin and then through the roof? I'd like to do this if possible to add a bit of protection from leakage. I've searched these forums and the Internet for photos of the inside of a shark fin without finding any. I assume a portion of it may be hollow and unused.

Thanks!

Search through this build thread, it's in there somewhere, lol: http://www.toyota-4runner.org/5th-gen-t4rs/100058-ducmonstas-build-thread-very-pic-heavy.html

Anyway, I think in that thread [MENTION=68685]Ducmonsta[/MENTION] posted a little how to about drilling through his XM antenna to feed wires to the roof rack, maybe it might give you some ideas

 

[jbstrd]

This is what [MENTION=85512]eddiebx[/MENTION] is referring to:

http://www.toyota-4runner.org/5th-g...ild-thread-very-pic-heavy-25.html#post1541747

 

[cmguss]

Thanks for the guidance!