KidVermicious
New member
So, I'm kinda stumped here. I've got an exhaust leak (I think) that I can't find, and it's driving me nuts. Here's the thing - the motor sounds fine at idle. In fact, it sounds fine through the entire rpm range when the truck is in neutral or the clutch is in with no load on the engine. It even sounds fine on the freeway or cruising down the street at low RPM. But as soon as I put my foot in it to accelerate, it sounds just like a little kid who's learned to stick out his tongue and blow raspberries, thpthpthpthpthpthpthpt. The other thing that makes me think it's an exhaust leak is it's quieter once the motor is good and hot.
So I've checked the manifold mating surface on the manifold and on the block, they're true. I've replaced the gaskets on both ends of the manifold, at the head and the pipe. I've helicoiled two studs that were loose in the head, and torqued them all to spec, ditto the three studs connecting the manifold to the downpipe. I've visually inspected the entire exhaust system, I don't see any broken welds or holes rusted through pipe or anything like that. Everything looks good, and since it won't do it in the driveway I don't know what else I can do to find this. I need to find it, because if it's not an exhaust leak then something is very very wrong.
Before I break down and take it in for a smoke test, any other ideas to isolate this thing?
So I've checked the manifold mating surface on the manifold and on the block, they're true. I've replaced the gaskets on both ends of the manifold, at the head and the pipe. I've helicoiled two studs that were loose in the head, and torqued them all to spec, ditto the three studs connecting the manifold to the downpipe. I've visually inspected the entire exhaust system, I don't see any broken welds or holes rusted through pipe or anything like that. Everything looks good, and since it won't do it in the driveway I don't know what else I can do to find this. I need to find it, because if it's not an exhaust leak then something is very very wrong.
Before I break down and take it in for a smoke test, any other ideas to isolate this thing?