5100's in, have a speed sensor code

[FireRescue14]

i posted this a few days ago and it got deleted when some threads where lost. I had 5100s put in all the way around, and i now have a right front speed sensor code. Before the thread was gone someone mentioned the ABS wire. The installer traced it and found no pinching. I have looked at other threads and have seen it can become stretched during install, bringing on the code. Anyone have experience with this? is it a PITA to put in new cable? The dash lights that are on are ABS, and trac control.

Thanks

 

[eddiebx]

You need to check each wire, if you over stretch the sensor cable, the sheathing can stretch but the copper wire inside it cannot; hence why you might have wires that appear to be fine externally, but are internally open.

 

[FireRescue14]

by using a multi meter down the wire?

 

[Stifler]

no by looking under the wheel well and seeing if the wire is snapped

 

[harper7]

by using a multi meter down the wire?

Yes, by using a ohmmeter to check continuity. The ABS wiring harness cost about $50 for each side and are easy to change.......ask me how I know.lol
Some people have just repaired or spliced in a new wire.

no by looking under the wheel well and seeing if the wire is snapped

They never appear "snapped" because as eddiebx just stated the wires are in a protective rubber sheath that stretches but the wires inside don't stretch and you can't see the break from the outside.

 

[Stifler]

They never appear "snapped" because as eddiebx just stated the wires are in a protective rubber sheath that stretches but the wires inside don't stretch and you can't see the break from the outside.

LOL....:evil:

 

[eddiebx]

^^There goes your attempt at being helpful instead of just trolling, :caked:

 

[jambo]

LOL....:evil:

Lmao

 

[Stifler]

^^There goes your attempt at being helpful instead of just trolling, :caked:

ya posting "SEARCH" was getting old