For anyone who is looking through this years from now.
BoM:
Complete King System
Front:
KING 25001-243A-EXT D/S RR Front Coilover Pair w/Compression Adjuster Knobs
Total Chaos 96504 UCA – Uni-Ball Upper Control Arm Set (#TCS 96504)
Rear:
KING 25001-279A D/S 4Runner 10+ 2.5" Remote Reservoir Rear Shock Pair, w/ Adjuster, 15.58" x 24.29"
102-1650- 195 - Pair of Sway-A- Way Rear 1.5" Lift Coils
+ 100lbs of steel sliders
There are a lot of variables when measuring to the ground. Tire air pressure, tire size (Which varies wildly depending on brand.), Aftermarket skid plates etc. The measurement Quebec gave is more of a clearance increase to some point on the vehicle, probably the front skid I would guess. It combines both the increased tire size and the increase in suspension lift. If you just want to know how much suspension lift you got then you need to know the initial hub to fender measurement was then what the new measurement is. The difference is the pure lift amount. Quebec said he got 4 inches of lift. Most of the OEM replacement kits are between 1" and 3" for 5th gen 4runners. And if they are adjustable can provide more or less than the stated amount of suspension lift. I personally get about 2 1/2-2 3/4" from my lift
I have natural body lean with KDSS - which is going to impact the lateral measurements wheel hub to fender.
At first installation I was:
Compared to stock
+4.5" avg of lift up front with
+2.6" avg in the rear (hub center to fender) -
this was changed almost immediately.
After lowering the fronts + a few
months of settling + 100lbs of sliders it measured.
Compared to stock
+3.3" avg up front and
+2.75" avg in the rear (hub center to fender)
The frame rake was reduced from the factory
1/2" difference on L and R side, to
1/4" difference rake on both sides - the rear of the frame still sits slightly higher than the front.
Clearance is indeed an additional 4" compared to stock.
If you have any additional questions, PM me.
OP has made his suspension choice, I'm glad he picked ICON. Whoever wrote the installation instructions for KING should be taken out back and shot.