ATL Newbie said:
2. Order these pieces from Scosche TA 1465b
I don't know yet how well they fit, they will arrive any day now.
T4RUSAF said:I just confirmed that the 3-wire hookup for nav on the 03/04 JBL 10-speaker amp WILL NOT work. I have the new seqouia amp it worked then swapped it out with the 10-speaker JBL amp and the voice dissapears. Folks from the Sienna forum have also comfirmed it.
ah yes.. many memories of getting smashed into a train in Shinjuku station.. the joys of rush hour in Japan. I am actually headed over there in a few weeks. Enjoy the yummy food.j0mama said:You work on the old one, and ill copy yours and change it for the new one
Im in Japan currently... Thats why i've been quiet... Im using public transportation here.
j0.
nyc4runnin said:i just installed the eclipse avn5500 into my 2004 sport with the same instructions as the toyota navi ..... good stuff and alot easier. only problem is the gps antena. i put it all the way back between the air ducts and i still get verrrrrrrryyy crappy reception. anyone have a pic of where they put theirs ? i would love to keep it under the dash. also i read that the backup cam wire was already in the dash for the 2004+ 4runners i didnt see it anywhere. is there a connector already in the tailgate for the cam ? or do i have to run the wire all the way back to the headunit ?
jcmr2 said:Pete, Seems you are the right guy to ask you some questions regarding a navigatio install. I purchased the 2007 Model for a Solara to OEMvalue.com but apparently this unit is a bit smaller in .
kiphartzell said:Lexusnut, Et al-
What was the Toyota P/N of the SR5 bezel that worked for you with the navigation system? I have a '06 Limited 4x4 4Runner Thanks.....
To All:
I recently installed the Toyota Navigation system from oemvalue.com in my 2003 4Runner Sport. There were a few issues I had in getting the system to work 100% (speed & reverse sensor, antenna amplifier). After a lot of research, the job is complete and I put together some instructions/downloads for anyone looking to complete the same.
Since there is a lot of data from the Shop Manuals, I put a link to my website so you can download.
Good luck and let me know what you think.
http://www.norgetech.com/navsup.htm
Pete
I just pulled two pins from the harness that were used for the rear audio (wireless headphones). Then I cut the wires and connected them to the "voice speaker/amp"