Install of PIAA 520 lights on a bull Bar

[duc8507]

Hello,
I have been searching this site to see it I can any detailed information / pictures on installing a pair of PIAA 520 fog lights on a Westin ultimate bull bar FOR A 2010 toyota 4runner. The instructions that come with the kit are very general. I am not concerned about bolting them on the bull bar as much as I am with the wiring. Here is my question:
1. What is the best way to route the wires from the bull-bar / grill to the interior driver’s side area on a 2010 Toyota 4runner? Firewall? Brake pedal??

Any help would be greatly appreciated; this is my first 4runner

 

[Ryan_S]

There is a big gasket that is only about half full of wires on the drivers side firewall. If you look in the engine compartment on the far right hand side it should be pretty apparent. I just popped a little + shaped hole with a knife and ran the wires through, then sealed it up with some silicone caulk.

edit: here's some install pics from mine on the "other" forum. http://www.toyota120.com/forum/showthread.php?t=16752

 

[duc8507]

Thanks Bro

Thanks for your help, I am going to give it ago this weekend.

I see you have the Baja rack, Is it worth the cash? I have been wanting to purchase it for some time now.

 

[Ryan_S]

…you have the Baja rack, Is it worth the cash? I have been wanting to purchase it for some time now.

I like it a lot. Its so easy to throw gear up there. I have a few SealLine waterproof bags to hold the stuff I don't want wet or dirty.