LED Tail Light Mod

M

mtnrider23

New member
Hi everyone!
Can anyone help me identify the wires in this pictures?
I'm trying to find the correct wires to splice in a resistor to eliminate the hyper flashing caused by using an LED turn signal.
In the pic (starting in the front/right and going clockwise), there is a red wire, a green wire with a yellow stripe, a blue wire, a solid green wire, and a white wire with a black stripe.
From what I know, I believe the white wire is the ground. Now I'm trying to figure out the turn signal wire. These are the two wires I need to splice the resistor into.
Thanks for your help in advance!!!
 

Attachments

  • IMG_0895.jpg
    IMG_0895.jpg
    134.5 KB · Views: 7,429
Register to hide this ad
Double check that blue wire, Is it blue with yellow stripe? If so, that should be directional for right side - blue/black for left side. Just confirm with a test light.
From the 2003 & 2006 wiring diagrams:
Green should be parking light
White/black is ground
Green/yellow should be brake
Red/yellow should be reverse
The above four should be the same on both sides, the directional will be different colors on each side.

What are you using for a resistor (specs)?
 
Helpful!

Thanks for your input. I'm waiting for some mounting plates before I finish the mod. I need to install resistors for the turn signal LED light to eliminate the hyper-flashing. I'll let you know how it goes. By the way, which manual were you referencing? I need to get my hands on a repair manual. Would you recommend one? Hayes or another??? Thanks again!
J
 
Finished!

You were dead on! Blue/Black=Lt. Turn Signal; Blue/Yellow=Rt. Turn Signal. The LED tail light mod. is complete! Pretty simple after figuring out the wiring. Thanks for you help!
J
 
You must log in or register to reply here.

Members online

Total: 236 (members: 3, guests: 233)

Forum statistics

Threads
278,306
Messages
3,554,046
Members
248,016
Latest member
Advally Service

Share this page

Trending content

Back
Top