How's it going everybody, been a long time. I've missed y'all. A few years ago my 04 was totaled due to idiot rear ending me . In my heart broken, frustrated stupidity I decided I was going to get something already fixed up instead of starting over. Well, I got an 06 Tacoma with six spd manual trans, icon coilovers, arp rear leafs and to top it off stage 1 URD s/c. After the first month I realized the truck needed some serious attention. Kept throwing a code for multiple misfire. I did things like new spark plugs, coil packs, new fuel injectors etc. when I thought it was bad cats I decided to go URD long tubes and well basically the exhaust that would make it stage 2, ordered a pulley and emailed URD for an online tune. Still didn't fix the problem, later found it was one of the exhaust cam gears off 1 tooth. Then the throw out barring went out in the clutch so we did a sleeve repair, heavy flywheel and stage two clutch. Forgot to mention it also had a lefty inchworm t-case. Anyway, during the time I was chasing issues I had a hunt come up that I needed something reliable for so I picked up an 03 4Runner sport 4.7 for 4500 bucks with 237k miles. My buddy that helped me work on the taco did a timing belt, water pump and new radiator. Later I sold the Tacoma. I've been driving the runner 55 miles a day for work and out to town on the weekends with the wife and hunting in the mountains here and there, all in 4hi cuz the 4lo actuator is stuck. It's got 318xxxk miles now. Original shocks and springs, original everything as far as I know other than some 255/70-17 ko2s take offs I put on when I first got it.
I need some 4.7 experienced owners to maybe give me some advice with some things I'm not sure is normal or not. I plan to get a Camry for work/town and I want to fix up what I have vs buy two new vehicles.
1: sometimes (with cruise control on) at 75 mph I run at different RPMs. Sometimes real good around 21-2200 other times 25-2600 same speed same freeway. The tranny has a dipstick so I have checked it and made sure it has the right amount. Also something else, on the highway coming down from the mountains, if I ride the brakes and slow enough I can feel an obvious downshift. That doesn't bother me but when I'm ready to pick up speed again it has a hard time with wanting to upshift, I have to play with the throttle a bit till it finally goes. I've been told three things, it's the torque converter, the transmission itself or the throttle position sensor. What say y'all?
2: the fan seems loud like a fords e-fan. Is this a 4.7 thing?
Anywho, like I said I want to fix it up. Should I start searching a used low mileage transmission, is it something else? Is there a "less complicated" fix for the 4lo motor? I saw a couple vids on YouTube but 'idunno' pretty sure I read on here that you have to disassemble the t-case should I source a new/used t-case as well?
Thanks in advance, It's nice to be back.
I need some 4.7 experienced owners to maybe give me some advice with some things I'm not sure is normal or not. I plan to get a Camry for work/town and I want to fix up what I have vs buy two new vehicles.
1: sometimes (with cruise control on) at 75 mph I run at different RPMs. Sometimes real good around 21-2200 other times 25-2600 same speed same freeway. The tranny has a dipstick so I have checked it and made sure it has the right amount. Also something else, on the highway coming down from the mountains, if I ride the brakes and slow enough I can feel an obvious downshift. That doesn't bother me but when I'm ready to pick up speed again it has a hard time with wanting to upshift, I have to play with the throttle a bit till it finally goes. I've been told three things, it's the torque converter, the transmission itself or the throttle position sensor. What say y'all?
2: the fan seems loud like a fords e-fan. Is this a 4.7 thing?
Anywho, like I said I want to fix it up. Should I start searching a used low mileage transmission, is it something else? Is there a "less complicated" fix for the 4lo motor? I saw a couple vids on YouTube but 'idunno' pretty sure I read on here that you have to disassemble the t-case should I source a new/used t-case as well?
Thanks in advance, It's nice to be back.