(it's really expensive)
The Trailhead Deflators do work good. I use the ARB deflator a lot though. I tend to run different pressures depending on the trail conditions.
If you air down, then you have to provide yourself with a way to air up. If the trails you are using don't provide an air station, this is a problem for the average person. There is one place I go that has air available at the ranger station. The other places are all privately owned parks and most don't have this. Since I don't have onboard air (it's really expensive) then it keeps me from being able to air down most of the time.
I agree that it makes for a better ride to air down. It does also improve traction. That's a documented fact. And it also makes the tires a little more puncture resistant.
But...airing down also decreases ground clearance and causes your undercarriage to get beat up more. In fact, on the trails here there are many places where 1" of ground clearance means cruising over the obstacle or getting hung up and having to work at it harder.
yup. lower pressure and wider tires for the really deep snow.Off the street, it depends. Sometimes you want to air down just a little so your tires can cut through to the frozen ground underneath, but if the snow is deeper than your frame it's generally a good idea to air WAY down and try to float on top. And go with a buddy. And have a winch. And a way to build a fire.![]()
So what tools do you all use to air down? Why do you like one type over another?
[MENTION=55855]zopperman[/MENTION], how much does that little tank help vs. filling them straight from the compressor? Seems like 1 gallon at 100 PSI ain't much.
Yeah, not so much. $50-$75 gets you a nice servicable air pump. Unless you're literally wheeling in your back yard, that's about what you'll spend on a single wheeling trip.
And for every obstacle that an extra inch of clearance makes the difference in crossing, there's fifty that you will trash your tires spinning and flailing against at street pressure while the guy in front of you walked up on aired down rubber.
Do y'all think one if the Viair 300C portable compressors would be a good option? Don't really want I run OBA just yet
Use the compressor from your RAS. It'll be slow but free
I though about that but I'm not sure if it would actually work or not
One way to find out![]()
core remover. ive considered some of the more expensive auto-deflators, but i dont wheel as often as i used to.
i usually pull all the caps, then remove a core. give it a good 10 count, then remove the rest. by the time the first one is down to where i want it, i can just go along and put the cores back in, and the rest are just about where i need them.
Do y'all think one if the Viair 300C portable compressors would be a good option? Don't really want I run OBA just yet