Just got done with the front portion of my lift using Toytec's coil-overs and have a question on pre and post measurements. My pre-measurement on both front from center of the hub to bottom of the fender was 19 1/4", and post is 23" passenger, and 22 3/4" on the driver.
I was wondering since my original XREAS system had around 110k on it if maybe the original factory measurement was 20" and just sagged over time. The cv angles look pretty good and the boot are not rubbing fins so I will more then likely keep the coils where they are at unless anyone thinks my current measurements are too high and will damage components if I keep it that way. Any input would be appreciated.
I was wondering since my original XREAS system had around 110k on it if maybe the original factory measurement was 20" and just sagged over time. The cv angles look pretty good and the boot are not rubbing fins so I will more then likely keep the coils where they are at unless anyone thinks my current measurements are too high and will damage components if I keep it that way. Any input would be appreciated.
