RC Cars (not about them, just a question)

[snivilous]

I need a miniature CV for an application for work, and have been browsing RC stuff, mainly Traxxas. Ideally I need a plastic CV, but more ideally I need to know what angles I can pull off of any of them. Or if someone knows of an alternative I could use... smaller is better (by small I'm meaning like 1/4" OD is getting pretty huge), plastic is better, cost doesn't really matter, and angle is important but none of the sites list an angle. Worse comes to worse I can just bolt a bunch together, but again I need to know how many I would need. And U-joints don't work, I have a 45 degree angle to a straight shaft to another 45 degree angle. Anything anyone can think of is helpful!

I'm too lazy/don't want to just order one from Traxxas and measure it and this gives me an excuse to go on t4r for work :bolt:

 

[Taco04]

Yup tons of them too choose from, Junfac, RC4WD, Traxxes etc most will probably go a 45 degree angle with enough space between the CVD's. Here are some photos that can give you some ideas.
Junfac Below


Traxxes below

 

[snivilous]

Yup tons of them too choose from, Junfac, RC4WD, Traxxes etc most will probably go a 45 degree angle with enough space between the CVD's. Here are some photos that can give you some ideas.
Junfac Below


Traxxes below

Perfect! Thanks man!

 

[KidVermicious]

Dang. I wish I could run a pinion angle like that.