zcruiser
Senior Member
Mine is also a 2000 v6 auto and running real lean & shuddering at about 2900 rpms, the exhaust is hot, converter is good, does this sound like your guys' also ?
Yep. Easy enough to pull a plug and check, though.
Mine is also a 2000 v6 auto and running real lean & shuddering at about 2900 rpms, the exhaust is hot, converter is good, does this sound like your guys' also ?
Tried new computer today, no difference, will try plugs & wires on Monday
Put new plugs in, no luck, new wires, no luck, still the same damn thing. What next ??
Can you go somewhere and pull codes just in case there's something there? Otherwise I'd say the throttle position sensor.
Had a similar issue a few years ago and ended up being the rear drive shaft. Seem just like a miss above 45 mph. I think if I remember correctly it would go away if I would accel quickly and would come and go at first and then slowly became constant.
All fixed , it was the crank sensor, new exhaust,new O2 sensor new plugs, new wires, dealer diagnosics 4 hours, changed MAF sensor, tried different computer, all one at a time with no avail. A small trouble shooting shop took it for a drive and said it was the crank sensor, I did not want to buy one so I got a used one to try and bingo, a 2 minute drive and he knew this, I wish that I went there first.Workin on the same problem.
Asked the same question, Tranny or Ignition?
Idles fine, starts e-z, but has some resistance in heavy acceleration and then the 55 shudder
Had a code, #5 cyl not firing. Rplaced the injector, changed the plugs - Bosch +2 (only dual electrodes I could find in town) But not the wires. Codes gone, doesnt buck as hard but still have the shuddering at 55ish speeds.
Ordering wires and then will try coil packs, But I also suspected the TPS, Its similar to a longago problem in an 86
TPS may come before the coil packs... One at a time I have to remind myself so I can pin point the issue
Exactly the same issue, so I figured since there were not codes being thrown Id start at square one, haha I replaced the spark plugs. AND that was it...that was it...F-ing spark-plugs.