Thanks! With water and Computers I totally forgot FLASHED not FLUSHED!
But idea is the same though :guitar3:
OF COUSE I REALIZED MY MISTAKE! WASNT That obvious.
BUT Everyone is missing my point here.
While power washing may be extreme, 1 inch of WATER in a cabin of an off road vehicle is NOT! I can see DAEWOO failing with that NOT A FREAKIN 4Runner! And I refuse to agree with ANYONE here that Cars need to be prepared and stuff for occasional water that enters inside.
IT IS A DESIGN FLAW!!! :ak472: AND I DO BLAME TOYOTA FOR IT.
NOT only I BLAME for Connector location (just 2" higher would NOT have fried my and yours ECU)
BUT, That connector carries Hi Voltage Hi Current Wires next to Low voltage low current computer Data wires. STUPID!
I am looking through Wiring manual to see where these connections go.
I suffered for everyone here and I feel like a freakin Jesus :smokin:
So to recap: I Should have expected 4Runner to be a p***y and carefully wiped 10 years of dirt, dust and salt. I should Disconnect my battery before Entering High water that MAY (God Forbid) enter inside of my Paved road capable 4 by 4. And lastly INSTALL Windows 8.1 on my ECM So the whole hunk of metal Stinks. :whipping2
I AM CORRECT HERE and TOYOTA IS NOT!
:lookout:
MY STOCK CAR WILL NOW BE PREPARED FOR WATER IN CABIN AND YOURS NOT! :frisky:
doors shut, water 3 feet deep that connector would not have gotten wet bottom line. the doors are sealed good, you let the water in not the truck.
and comparing yourself to Jesus because you suffered your own stupidity is a far cry from reasonable, but you have proven yourself to be unreasonable on more than one occasion here, so I should not expect more.
Sit down, take a break, stop making stupid decisions, and then go learn to wheel your very capable off road vehicle.