Thread Pitch for Clutch Master and Slave ?

[VernySanders]

Im going to do a custom clutch line, anyone know the thread pitch for these? I plan on getting threaded AN fitting adapters to do a stainless braided PTFE line.

 

[Team_Jake]

Dorman specs the threads as M10x1mm, I'm not 100% sure that's accurate though. When I did my swap I got a Marlin Crawler steel braided clutch line, it's a quality line and works perfectly.

 

[VernySanders]

Dorman specs the threads as M10x1mm, I'm not 100% sure that's accurate though. When I did my swap I got a Marlin Crawler steel braided clutch line, it's a quality line and works perfectly.

I appreciate that! I will look further into it, I wouldnt mind buying the line from Marlin, I just have so much of this braided stainless line I figured i'd just make one myself. Maybe Marlin will second the M10x1mm, ill email them and see if i get a response. Thanks!

EDIT: I ordered two billet aluminum 6AN to M10-1MM adapter fittings. Hopefully its the right pitch. I looked around it seems this is the pitch toyota has used since the 80's on clutch lines. Marlins line connects two hard lines, I am going to do a 6AN stainless braided line custom from the Master all the way to the slave.

 

[RandyBobandy]

It is 10x1, same as the brake lines, don’t tell anyone but I’m running a brake line in place of the soft clutch line on mine lol

 

[VernySanders]

It is 10x1, same as the brake lines, don’t tell anyone but I’m running a brake line in place of the soft clutch line on mine lol

hahah gnarly! that makes me happy to have it confirmed because now I know I didnt waste any money on these two billet adapters