TRD Mountin Decal?
- Thread starter Ol'Blue
- Start date
Register to hide this ad
Swimmerboy2112
New member
That's goddamn sexy! I have it on my Tacoma :thumb3:
A.Wilson013
New member
If I were a fan of stickers/decals I would have a set of those. I REALLY like the way they look.
fiercefoxie
New member
^ I like it like that!
fightman80
New member
It's not hard to do man... just be methodical about it.
First: tape off a straight line to reference from.
Second: spray the quarter panel with soap and water mix
Third: remove backing and place decal on surface, using your tape mark to keep you level
Fourth: use a credit card to press out any bubbles and excess water from behind the decal.
Fifth: Let sit in sun for approximately an hour, or until surface is thoroughly dry. You can test pealing up your decal in a small portion... to see if the decal lifts off the surface of the quarter panel. *(It should not)
Sixth: Remove the entire top layer of your decal (clear tape), and enjoy your new decal!
Please correct me if I'm wrong folks... as it's been a few years since I last did some.... but pretty sure this is the method used.
First: tape off a straight line to reference from.
Second: spray the quarter panel with soap and water mix
Third: remove backing and place decal on surface, using your tape mark to keep you level
Fourth: use a credit card to press out any bubbles and excess water from behind the decal.
Fifth: Let sit in sun for approximately an hour, or until surface is thoroughly dry. You can test pealing up your decal in a small portion... to see if the decal lifts off the surface of the quarter panel. *(It should not)
Sixth: Remove the entire top layer of your decal (clear tape), and enjoy your new decal!
Please correct me if I'm wrong folks... as it's been a few years since I last did some.... but pretty sure this is the method used.
TheArkMaster
New member
It's not hard to do man... just be methodical about it.
First: tape off a straight line to reference from.
Second: spray the quarter panel with soap and water mix
Third: remove backing and place decal on surface, using your tape mark to keep you level
Fourth: use a credit card to press out any bubbles and excess water from behind the decal.
Fifth: Let sit in sun for approximately an hour, or until surface is thoroughly dry. You can test pealing up your decal in a small portion... to see if the decal lifts off the surface of the quarter panel. *(It should not)
Sixth: Remove the entire top layer of your decal (clear tape), and enjoy your new decal!
Please correct me if I'm wrong folks... as it's been a few years since I last did some.... but pretty sure this is the method used.
I actually worked with vinyls for about a year and honestly, you don't have to let it sit that long. You can get away with 5 minutes
The sun or heat will take out any bubbles that you couldn't squeegee out.
If anybody has questions, I know way more about this stuff than i'm proud of...
Limbwalker
New member
Want.
BlazeRunner
Member
I didn't know whether this thread was going to be about mounting decals or mountain decals... but I vote yes!
RussToy
New member
X2!!!
I also would like to know where you can get a set of these?? I already have the TRD...but sure would like to add the mountains. Love that look...thanks!!
TideRunner
New member
this one was on my rig when i bought it
