Thanks! Not sure how I've not seen these before now, that's exactly what I need until it is time for a full rack.
What did you do to/in your 5th Gen today?!
- Thread starter DEKA3
- Start date
Thanks! Not sure how I've not seen these before now, that's exactly what I need until it is time for a full rack.
Friggin Idiot
Senior Member
Nice, hoping I can wrangle a friend to help me with mine tomorrow! Anything to watch out for on the install?
JSparky
New member
Installed a new switchable (White/Red) LED Map light.
That’s awesome. I do a lot of astronomy and should look into this. Back when I had my JK, there was no “push-on” interior light so I put a Petzl TacTica headlamp on the overhead bar using a climbing helmet mount. That light had a red filter you could fold down to achieve the same effect, it was super helpful.
So these LED’s are switchable from red to white? I wonder if you could swap all the interior lights out for these.
anomalous
New member
Awesome, got the same kit? The install is pretty straight forward. Keep everything loose until you have all the pieces connected and lined up. Hardest piece for me to get lined up was the tail pipe side, gotta fight with the rubber hanger a little bit to line up the pipe to the section that goes over the axle. Might have been easier to take the rubber hanger off of the car side, line up the pipe first, then reattach the hanger. Good luck!
anomalous
New member
No, I wouldn't call it drone, but you can definitely hear the exhaust, but only when you're getting on it. When cruising and light throttle maintaining speed, you can barely hear it. My truck is completely sound deadened, too, which probably helps compared to a stock interior
How much was everything after shipping?
I got all the parts listed in the other thread including the guage, $238 shipped. Took about 1:30 min to install. Was very easy just took alot of time removing the black tape from the harness to separate the MAF sensor wires from the rest of the harness.
oljedi11950
New member
Changed my plugs @ 85678k no pics but [MENTION=65614]Antman[/MENTION] & Gracie provided many ! Even a 67 yr old can do it ! (with pics) of course
spotman944
New member
Stock suspension and no lift?
4Runner_Fritzy
New member
oljedi11950
New member
Oh ya wheels & tires
Attachments
Thanks. Been debating the TRD or AFE.
Was that included the TRD air filter?
No it wasn't. I just purchased our 16 SR5 so there is a new paper filter in it, run it until it needs replaced. More than likely i'll then get a K&N filter since it's the same filter for the TRD intake or stock. I run K&N in our other car, my streetbike and track bike so I always have cleaning / recharge supplies on hand. If I get the TRD filter later I'll need yet another kit...
I'm not sure about the AFE but for me, I figured go with the TRD since it's a Toyota part/kit. Everything fit great, no complaints.
Similar threads
